1.5KW 20m Electric Swimming Pool Spa Water Pump Swimming Pool Clean Pump Strainer
| Model |
Voltage |
HZ |
Power (KW) |
Power (HP) |
Hmax (m) |
Qmax (m³/h) |
Port Size (inch/mm) |
| FQ-150 |
220V-240V |
50 |
1.1 |
1.5 |
18 |
29 |
2.0/63 |
| FQ-200 |
220V-240V |
50 |
1.5 |
2 |
20 |
36 |
2.0/63 |
| FQ-300 |
220V-240V |
50 |
2.2 |
3 |
21 |
39 |
2.0/63 |
| FQ-350 |
220V-240V |
50 |
2.6 |
3.5 |
22 |
40.5 |
2.0/63 |
| FQ-400 |
380V |
50 |
3 |
4 |
23 |
49 |
2.0/63 |
Features:
Ask Technical informations to local agent or wholesaler. that can prove the are
qualified supplier, you can also order spare parts from them, Give the following
information when ordering repair parts:
1. Unit nameplate data or serial label number
2. Description of part
SERVICE & REPAIR PARTS
MOTOR DOES NOT START
FAULT ANALYSIS
1. Disconnect switch or circuit breaker off position
2. Fuses fusing or thermal protector open
3. Locked motor shaft
4. Motor winding burned out
5. Defective staring switch inside single phase motor
6. Disconnected or defective wiring
7. Low voltage
Release all air from fitter and piping system: see filter owner manual
In a flooded suction system (water source higher than pump),
pump will prime.
it self when suction and discharge valves are opened.
If pump is not in a flooded suction system, unscrew and remove cap
cover; fill cap and pump with water.
Clean and inspect Ring; re-install on trap cover.
Replace cap cover on cap turn clockwise to tighten cover.
PRIMING PUMP
STANDARD OFF CENTRE DISCHARGE: Pumps used on many spas from various spa manufacturers from 2000 onwards. Suitable for all types of spas including Salt, Chlorine, Bromine and Ozone Chlorination. Corrosion Resistant and Chemical-resistant thermoplastic body. Suitable for above ground and in ground spas. If used on a in ground spa and the pump is above the water level then select one of our self-priming pumps from our other listings. If center discharge is required then check our other listings.
WITH A FULL RANGE OF SIZES, they are IDEAL FOR SMALL, MEDIUM and LARGE spas – Our pumps start from the 0.5 HP for circulation pumps up to the 3HP for spa jets and a full range of sizes in between. Connection fittings for standard PVC 2inch (48.5mm) pipe.
HOW TO USE – It is best to always replace your pump with a pump of similar size and power rating. Changing over and fitting of the pump can be done by the handy person but it is recommended to get it done by a professional. Suitable as a direct replacement OR upgrade to existing pump.
Product Tags:
|
|
1.5KW 20m Spa Water Pump Single / Three Phase Low Noise Operation Images
|
